Raw material preparation:

1. Raw materials for biomass pellet machine production: After crushing biomass fuels (wood chips, rice husks, peanut husks, etc.), mix them evenly in a certain proportion. Wood fiber powder can also be used instead of wood chips or rice husks. Depending on the actual situation in different regions. Straw raw materials should be chopped short before being mixed and processed into granules; If wooden cellulose powder is used as the raw material, it does not need to be chopped and can be mixed directly.

2. Auxiliary materials: water, electricity, and site.

Process:

The production process of biomass pellet machine is:

1. Material preparation → drying → granulation → cooling → finished product packaging → warehousing and storage. (Note: The specific process can be designed according to user requirements.) After crushing, the material enters the drying room for drying treatment. When the moisture content is less than 10%, it enters the granulation room for granulation. When the moisture content is greater than 30%, it enters the cooling room for dehydration and drying treatment. Then, after screening by the screening device, it becomes a granular product packaged as a finished product. (Note: The specific process can be designed according to user requirements.)

Main equipment:

1.Biomass pellet machine host;

2.Crushers, crushers, dryers, cooling machines and other auxiliary equipment;

3.Supporting equipment.

Key points of operation:

1. Before the machine works, check whether all parts operate normally? Is there any abnormal situation? If there is a malfunction, it can only be operated after timely troubleshooting.

2. Before starting the machine, first check whether the oil in the gearbox is sufficient? The oil level should be at the oil mark.

3. Before starting the machine, it is necessary to check whether the screws in each part are loose or falling off.

4. Before starting the machine, the motor must be started and run for at least 2 minutes before starting the spindle to rotate for at least 5 minutes before feeding for production.

5. If any abnormal phenomena occur during the production process, the machine should be shut down for maintenance in a timely manner.